Bracket create angle from 0 to 44 degree
This connector works as designed. It's basically a thicker chunk of vinyl connector. You have to figure out the angle you need and cut it to fit your application. I have a nice compound mitre saw that I used for this DIY project, but in almost all cases I could not use the saw because the bracket was too small to hold safely to cut my desired angle. I ended up cutting at least 4 connectors with a Dremel tool which worked fine. Some of the lines are not exactly clean, but it doesn't look bad. I figured I'd caulk if necessary, but so far it doesn't look bad enough for me to take the time to caulk it. Overall, this allowed me to obtain the desired look with the new railing in my non-standard, non-square existing deck.
